¡@
Circular Internal Nuts | |||||
|
|
Unit:mm |
Size-No. | Ring dimension | Applicable bore | Thrust load kgf |
|||||||
D | d | t | Nos.of Teeth |
S | ||||||
Basic | Tol. | Basic | Tol. | Basic | Tol. | |||||
CRTW- | 6 | 6.2 | 0 ¡Ð0.1 |
2.2 | 0.2 | 0.25 | 6 | 6 | 0.03 | 20 |
8 | 8.2 | 3.6 | 0.25 | 6 | 8 | 20 | ||||
10 | 10.2 | 5 | 0.25 | 6 | 10 | 18 | ||||
12 | 12.2 | 6.6 | 0.25 | 6 | 12 | 15 | ||||
14 | 14.2 | 8.2 | 0.25 | 6 | 14 | 13 | ||||
16 | 16.2 | 9.8 | 0.25 | 6 | 16 | 12 | ||||
18 | 18.8 | 11 | 0.4 | 8 | 18 | 30 |
¡´Material= Carbon spring steel. Hardness=HRC40~50. Finish=Black phosphate coating (ACP). | |
Note; | 1.The data of
thrust load shows the value when the nut is tested by the bore made of cold rolled steel. 2.This ring can not use of hardened bore. |
¡@