¡@

Circular External Nuts

6-5-2-1p.gif (3880 bytes)
6-5-2-2p.gif (6340 bytes)
Applicator
6-5-2-3p.gif (6002 bytes)
Unit:mm
Size-No. Ring dimension Applicable shaft Thrust
load
kgf
d D t Nos.of
Teeth
S
Basic Tol. Basic Tol. Basic Tol.
CSTW- 2 1.9 0.05
6 0.2 0.25 3 2 ¡Ï0.03
¡Ð0
6
2.4 2.2 ¡Ï0.1
0
6.4 0.25 3 2.4 ¡Ï0.03 6
3 2.8 8 0.25 4 3 9
3.5 3.3 0
0. 1
7.5 0.25 4 3.5 10
4 3.8 ¡Ï0.1
0
9 0.25 4 4 12
4.5 4.3 10 0.25 5 4.5 14
5 4.8 10 0.25 5 5 16
6 5.8 11 0.25 5 6 18
8 7.8 13 0.25 5 8 21
10 9.8 15.4 0.25 6 10 21
12 11.8 17.8 0.3 0.4 6 12 23
14 13.8 20.3 0.4 6 14 0.05 23
16 15.8 22.8 0.4 6 2 23
18 17.8 25 0.4 8 18 25
19 18.7 0.15 25.4 0.4 6 19 25
20 19.8 ¡Ï0.1
0
28 0.4 8 20 25
22 21.7 0.15 28.5 0.4 6 22 25
¡´Material= Carbon spring steel. Hardness=HRC40~50. Finish=Black phosphate coating (ACP).
¡´Material=Stainless spring steel.
Note; 1.The data of thrust load shows the value when the nut is tested by the shaft made of cold rolled steel.
2.This ring can not use of hardened shaft.

¡@